Kitchen Gadgets

Garbage Disposal Not Working? 6 Fixes for Humming, Jams and No Power

A garbage disposal not working is usually tripped, jammed or stuck: press the red reset button on the bottom of the unit, free the blades with the hex key that fits the socket underneath, and check the breaker. Always switch the power off first and never put your hand in the drain.

Contents
  1. 1Short answer
  2. 2Garbage disposal not working: 6 fixes
  3. 3Symptom, cause and fix
  4. 4What causes most jams
  5. 5Tips to prevent the next breakdown
  6. 6When a garbage disposal not working means replacement
  7. 7Quick FAQ
  8. 8Recap
  9. 9Final thoughts

Most disposal problems are fixable in ten minutes with no plumber. Figure out which symptom you have, then follow the matching fix below. Keep a flashlight and a pair of tongs nearby.

garbage disposal not working: pressing the red reset button under a disposal

Short answer

If it’s silent, press the reset button and check the breaker. If it hums but doesn’t spin, it’s jammed: turn the hex key in the bottom of the unit back and forth, remove the obstruction with tongs, then reset. If it leaks, the fix depends on where the water comes from.

Garbage disposal not working: 6 fixes

  1. Turn off the power. Flip the wall switch off and, if it plugs in under the sink, unplug it before any fix.
  2. Press the reset button. It’s a small red or black button on the bottom of the disposal. If the motor overheated, it pops out; push it in firmly.
  3. Check the breaker. If the reset didn’t help, look for a tripped breaker in your panel and switch it fully off, then on.
  4. Free a jam with the hex key. Insert a 1/4-inch hex key (often included with the unit) into the center socket underneath and work it back and forth until it turns freely.
  5. Remove the obstruction. With the power still off, shine a flashlight in the drain and pull out anything stuck using tongs or pliers.
  6. Reset and test. Press the reset button again, run cold water, then turn it on.

The maker’s own InSinkErator jam guide uses the same steps: power off, free the jam, reset.

garbage disposal not working: turning a hex key in the bottom of a disposal

Symptom, cause and fix

SymptomLikely causeFix
———
Completely silentTripped reset or breakerPress reset, check breaker
Hums but won’t spinJammed flywheelHex key, remove object, reset
Runs but drains slowlyClog in the drain lineClear the trap or call a plumber
Leaks from the topLoose sink flangeTighten or reseal the flange
Leaks from the sideLoose dishwasher or drain connectionTighten the hose clamp
Leaks from the bottomWorn internal sealUsually replace the unit
A leak from the bottom of the unit usually means the disposal itself has reached the end of its life.
garbage disposal not working: removing a bottle cap from a disposal with tongs

What causes most jams

  • Fibrous food: celery, corn husks and onion skins wrap around the parts.
  • Starchy food: pasta, rice and potato peels swell into paste.
  • Grease: it hardens and traps everything else.
  • Hard objects: bottle caps, fruit pits, bones and the occasional spoon.
garbage disposal not working: a disposal wall switch beside a kitchen sink

Tips to prevent the next breakdown

  • Run cold water before, during and for about 15 seconds after grinding.
  • Feed scraps slowly instead of stuffing in a full plate at once.
  • Clean it weekly with ice and a little baking soda to keep the chamber clear.
  • Keep the hex key handy. Tape it to the inside of the cabinet door so you’re never hunting for it.
  • Run it often. A disposal that sits unused for weeks can rust and seize.

When a garbage disposal not working means replacement

If the motor won’t run after a reset and a clear breaker, or the unit leaks from its bottom, it’s often time for a new one. Many home disposals last around 10 years. A plumber can also check whether the wiring or switch is at fault before you buy.

Quick FAQ

Why does my disposal hum but not work? The motor gets power but the flywheel is jammed; free it with the hex key. Can I use drain cleaner in a disposal? It’s best not to, since harsh chemicals can damage parts and splash back. Where is the reset button? On the underside of the unit, usually near the center or the edge.

Recap

  • Silent: reset button, then breaker.
  • Humming: jam; hex key and tongs.
  • Leaking: find the spot; bottom leaks usually mean replacing it.

Final thoughts

Most of the time, a dead disposal just needs a reset or a quick unjam. Keep it running smoothly with a weekly clean using our guide on how to clean a garbage disposal.

Your turn: what’s the strangest thing that has jammed your disposal? Tell us in the comments.

This guide is based on research and manufacturer guidance, not our own testing.

Related guides: Dishwasher not draining · How to clean a dishwasher

Leave a Comment